The nitinol core coronary wire - width should be 0.014 in diameter and length of 180 cm or more. the tip weight should be less than one gram. should have hydrophilic coating. should have 1:1 torquability. should be compatible with dock extension wire

Hydraulic oil brand: ioc (barrel should be ms only)

1) tapered drill router should be compatible with existing stryker neuro drill system, 2) lindemann drill bit should be compatible with existing stryker neuro drill system, 3) pd series perforator chuck should be compatible with existing stryker neuro drill system & 4) perforated drill bit large should be compatible with existing stryker neuro drill system

Spo2 sensor probe for use with multiparameter monitor of make g3d. the probe should be minimum 3 metres in length.each probe should be individually packed.

Floor end profile,l=2000mm, as per drawing: lw41112, packing instruction: as per standard packing. it should be ensured that item should not rub during transportation.the item should be packed with adequate strength.

Tab/cap . bilastine 20 mg. ( product should be in railway board)

Solid state relay for control safety loop, dc3-32 v confirming to rcf specification no. edts 103 rev-d, am-7. material is rd0605-d of m/s carlo gavazzi/abb/siemens or equivalent. note: 1) material should be should be supplied by oem or their authorised dealers only & dealership certificate should be uploaded while bidding. 2) test certificate & guaranty certificates should be supplied along with materials.

Suture anchor should be made of peek material 4.75mm./ suture anchor should be made of peek material. 5.5 mm. / low profile titanium cancellous screws of diameter 4.0 mm and 6.5mm.

Monthly basis cab and taxi hiring service - without fuel - muv diesel covered 12 seater multi utility van ( muv) with ac ie trax toofan or equivalent the offered vehicle should not be more than three years old from the date of its first rto registr..

Chlorine tablets for use in ir-drdo bio-toilets confirming to rcf specification mdts-14274 rev-00. technical requirements: 1. the tablet size should be 78 mm diameter and weight should be of approximately 200 g. 2. the tablet should have active molecule of 3, 5 di-chloro-isocyanuric-acid. 3. it should have effective chlorine of >= 50 percent chlorine. 4. the tablet should have formulated for sustained release (should last for at least 21 days in tap water). 5. moisture content should be