Echp-i- replacing the existing wornout skirt board assembly by new skirt board assembly for conveyor-43 at pch-i.

Supply of cage frame assembly suitable for secondary crushers 1a 1b 2a 2b at sch ii

1600206578 drive arrangement with motor & gearbox,1600206579 non-drive wheel shaft assembly. for c-605 with plummer block, bearings, shaft & wheel

Lpp 2712g assembly of long travel bogie with wheel bearing drive shaft, locking pin for staker,slewing drive shaft unit assembly for stacker reclaimer of coal handling plant of 500mw unit no 6

Job contract for replacement of top stop assembly including locking gear rack arm and top girder of wagon tippler tp 193 and replacement of spur gear shaft assembly including erection of spur wheel alignment testing and commissioning of wagon tipp

1 - ecentric shaft with 2 nos. key for fly wheel and 2 nos. key for labyrinth seal, drawing no. - mark no. 1-154-011,1-154-a-011 make- tega mcnally mineral limited,2 - pitman housing cover, drawing no. - mark no. 2-332-012, 2-332-a-012 make- tega mcnally mineral limited,3 - intermediate labyrinth seal, drawing no. - mark no. 1-154-007, 1-154-a-007 make- tega mcnally mineral limited,4 - fixed side bearing inside cover, drawing no. - mark no. 1-154-007, 1-154-a-007 make- tega mcnally mineral limited,5 - fixed side bearing inside cover, drawing no. - mark no. 1-154-007, 1-154-b-007 make- tega mcnally mineral limited,6 - side bearing sleeve with pin, drawing no. - mark no. 2-332-016, 2-332-a-016 make- tega mcnally mineral limited,7 - sleeve push type removal, drawing no. - mark no. 3-145-010, 3-145-a-010 make- tega mcnally mineral limited,8 - lock washer w-36 make- tega mcnally mineral limited,9 - lock nut, an-36 make- tega mcnally mineral limited,10 - fixed side bearing cover, drawing no. - mark no. 2-332-014, 2

Echp-ii- fixing the new en-24 shaft of an second hand healthy 4 wheel assembly of pc-2b at pch-ii.

Echp-i- replacing the existing worn out support wheel assembly by new support wheel assembly for pc-1b at pch-i.

Echp-i- replacing the existing worn out bend chutes by new bend chutes for pc-1a 1b at pch-i.

Supply of new flow divider for receiving chute of pc 1a and 1b at pch i