The nitinol core coronary wire - width should be 0.014 in diameter and length of 180 cm or more. the tip weight should be less than one gram. should have hydrophilic coating. should have 1:1 torquability. should be compatible with dock extension wire

Hydraulic oil brand: ioc (barrel should be ms only)

1) tapered drill router should be compatible with existing stryker neuro drill system, 2) lindemann drill bit should be compatible with existing stryker neuro drill system, 3) pd series perforator chuck should be compatible with existing stryker neuro drill system & 4) perforated drill bit large should be compatible with existing stryker neuro drill system

Spo2 sensor probe for use with multiparameter monitor of make g3d. the probe should be minimum 3 metres in length.each probe should be individually packed.

Floor end profile,l=2000mm, as per drawing: lw41112, packing instruction: as per standard packing. it should be ensured that item should not rub during transportation.the item should be packed with adequate strength.

Tab/cap . bilastine 20 mg. ( product should be in railway board)

Ring complete (welding joint of this item should be leakage proof)

Group-a bare pipe as per specifications to be quoted in gem inclusive of gst,group b- plug valve as per specifications to be quoted in gem inclusive of gst,group c -ball valve & actuator valve as per specifications to be quoted in gem inclusive of gst,group d- insulating joint as per specifications to be quoted in gem inclusive of gst,group e- flow tee as per specifications to be quoted in gem inclusive of gst,group f-fittings(lr bend, elbow, tee, reducer, end cap, coupling, weldolet, nipple etc. ) as per spec,group g-flanges(wnrf, blrf, spbl) as per specifications to be quoted in gem inclusive of gst,group h-studs with both side nuts as per specifications to be quoted in gem inclusive of gst,group i- spiral wound gasket as per specifications to be quoted in gem inclusive of gst

Suture anchor should be made of peek material 4.75mm./ suture anchor should be made of peek material. 5.5 mm. / low profile titanium cancellous screws of diameter 4.0 mm and 6.5mm.

Facility management services - lumpsum based - industrial servicing of acb consumables to be provided by service provider (inclusive in contract cost),facility management services - lumpsum based - industrial servicing of acb consumables to be provided by service provider (inclusive in contract cost),facility management services - lumpsum based - industrial servicing of acb consumables to be provided by service provider (inclusive in contract cost),facility management services - lumpsum based - industrial servicing of acb consumables to be provided by service provider (inclusive in contract cost),facility management services - lumpsum based - industrial servicing of acb consumables to be provided by service provider (inclusive in contract cost)