5 french fixed curve quadr [srphc82276005-5 french fixed curve quadripolar electrode catheter with 2-5-2 inter electrode spacing. one matching connecting cable should be provided free of cost for every three catheters. should be dcgi approved.]

The nitinol core coronary wire - width should be 0.014 in diameter and length of 180 cm or more. the tip weight should be less than one gram. should have hydrophilic coating. should have 1:1 torquability. should be compatible with dock extension wire

7 french quadripolar radio [srphc82276035-7 french quadripolar radio frequency ablation catheter with a 4 mm tip and bidirectional deflection . should be available in small, medium and large curves. should be compatible with all available leading brands of radio frequency generators. one matching connecting cable should be provided free of cost for every three catheters. should be dcgi approved.] , french or 8 french quadr [srphc82276030-7 french or 8 french quadripolar radio frequency ablati

Hydraulic oil brand: ioc (barrel should be ms only)

1) tapered drill router should be compatible with existing stryker neuro drill system, 2) lindemann drill bit should be compatible with existing stryker neuro drill system, 3) pd series perforator chuck should be compatible with existing stryker neuro drill system & 4) perforated drill bit large should be compatible with existing stryker neuro drill system

Spo2 sensor probe for use with multiparameter monitor of make g3d. the probe should be minimum 3 metres in length.each probe should be individually packed.

Floor end profile,l=2000mm, as per drawing: lw41112, packing instruction: as per standard packing. it should be ensured that item should not rub during transportation.the item should be packed with adequate strength.

Tab/cap . bilastine 20 mg. ( product should be in railway board)

Facility management services - lumpsum based - commercial housekeeping consumables to be provided by buyer

Bearing wiper pe for traction motor type 4303by, dy as per bhel drawing no. 34394328002, or s.n. enterprises part no. sne/bwpe/24. note - 1) company name and p. o. no. should be embossed on component, 2)material should be finished machined on cnc and dimensional report along with 3d cmm report to be provided. 3) material to be supplied with anti corrosion coating in wooden box and material to be wrapped with bubble wrap.