Repairing of 06 nos. pin and bush of rear tierod and both rear suspension pin bush and repairing of cracked chassis and propeller shaft of cat 777d dumper sl. no. 2221 of kdh project, n.k. area.

Repairing of 04 nos. track tensioners assembly of recp650 drill, sl. no.6021703/rdc-1401 and 6021401/rdc-1289 of gvp ph ii ocp.

Repairing of bucket assembly and changing of 08 nos. tooth point, repairing of adaptor by welding, grinding, along with repairing of edge segment, fabrication of battery box, ladder new making, transmission guard fabrication and dismantling, overhaul

Repairing of vibration damper after removal of broken bolt, thread making, repair of propeller and drive shaft guard, replacement of uj cross, repair of cracked h-frame and&#x0d repair d-90022 of kdh project

Removal, repair and fitment of hoist cylinder both side, replacement of bearing of hoist cylinder, repair of rear part of dump body and dump body locking part, repair of canopy and fabrication of engine, trans guard and drive shaft guard of dumper 12

Repairing of both side of under carriage track chain of total 06 nos. of track pads changing from serviceable old chain with 04 nos. track guard straightening and fitting,repairing of yoke center hole and pin material filling of idm-30 dril 826

(a) dismantling of drum and equalization pinion with guard and refitting of drum after changing of f/b no.4 (b) repairing and reassembling of broken chain conveyor of f/b no-4 and (c) replacement of defective motor of f/b no-5 of amp colliery.

Changing of upper and lower (both side) damaged radius arm eye housing and new bushing fitting and welding of broken mounting eye and repairing of output shaft of dumper assembly opening, drive line opening and dumper assembly dismantling of 10327

Repairing of rear and left side railing straightening welding, fitting with nut bolt, compressor oil cooler cleaning, gauging work and complete repair of lhs chain guard 02 nos. with tap threading work fitting and welding work idm-30 drill sl. no 752

Dismantling, repairing and fitment of take-up axle, take up wheel, idler wheel, intermediate shaft housing, propel shaft housing, bearing axle and repair of both side final drive of ekg 5a shovel sl.no. hmb-565 of gidi-c colliery.