Pacer with mask for child [srphc82337065-spacer with mask for children.1)it should be suitable for use for infants and children.2)the minimum capacity of the holding chamber should be approximately 250cc(ml).3)the holding chamber should have a valve to prevent rebreathing of the exhaled air.4)should be made of polymer /polycarbonated material.5)should have a mask of pediatric size suitable for covering the nose and mouth of the infant and children.6)should be compatible with the mdi which is b

The nitinol core coronary wire - width should be 0.014 in diameter and length of 180 cm or more. the tip weight should be less than one gram. should have hydrophilic coating. should have 1:1 torquability. should be compatible with dock extension wire

Hydraulic oil brand: ioc (barrel should be ms only)

Solar traffic signal at 13 location

1) tapered drill router should be compatible with existing stryker neuro drill system, 2) lindemann drill bit should be compatible with existing stryker neuro drill system, 3) pd series perforator chuck should be compatible with existing stryker neuro drill system & 4) perforated drill bit large should be compatible with existing stryker neuro drill system

Spo2 sensor probe for use with multiparameter monitor of make g3d. the probe should be minimum 3 metres in length.each probe should be individually packed.

Floor end profile,l=2000mm, as per drawing: lw41112, packing instruction: as per standard packing. it should be ensured that item should not rub during transportation.the item should be packed with adequate strength.

Tab/cap . bilastine 20 mg. ( product should be in railway board)

Suture anchor should be made of peek material 4.75mm./ suture anchor should be made of peek material. 5.5 mm. / low profile titanium cancellous screws of diameter 4.0 mm and 6.5mm.

Eto 2 cartridge. should be compatible to steri techno fab, model stf/eo/71