Temperature thermometer,drier core,atu v belt,condenser end cover gasket,zinc anode with brass cap,vibration mounting for atu,vibration eliminator,vibration eliminator,compressor oil,suction pressure guage,discharge pressure guage,posv valve with coil,atu cooling thermostat,ahu blower bearing with sleeve and locking arranging,high pressure cut out,water flow switch,expansion valve,angle valve,hand shut off valve 3 by 8,angle valve 5 by 8,low pressure cut out switch,condenser safety valve

Water temp sensor,acc cable,bty cut off switch,relay 12v,clutch master cyl assy,clutch sleeve cyl assy,injector nozzle,rear glass

Bush king pin,ball bearing,part kit brake chamber,cover assy,assy sleeve cyl,fuel filter cum water separator,seal kit,housing,clutch drive,h p hose,thermostate valve,transfer case bracket,armature assy,solenoid switch,battery cut off switch,repair kit frt spring brake actuator,seal plain encased,gear spar,system protection valve

Traction transformer complete with cooling system & accessories like h.t. cable along with protection shield in passenger compartment and underframe area, thermostat etc. related protection equipment and with safety chain arrangement including termination crimping lugs, cable markers with heat shrinkable sleeves for power and control cables, equipment mounting and earthing hardware and accessories as per attached specification suitable for 3 phase memu (medha, on-board).

Disconnecting and earthing device, 8 pole, 2 way, no-off on load, 63a 750v ac (1000v insulation), 2no + 2nc with heavy handle and pad locking arrangement. in earth position, mounted in a stainless steel enclosure suitable for ac 23 duty conforming to is 13947/iec 947, to drawing no. m137, 0827407 of m/s schaltbau or catalogue no. 73342slb321 ogb of m/s l&t as per spec.no. edts 355 rev.1 amdt as per drg.no. n/a specn: is/iec 60947-3 (1999)

Disconnecting and earthing device, 8 pole, 2 way, without off, on load 125 amps at 1000v ac, 2no+2nc and with heavy handle and pad locking arrangement in one position, mounted in a stainless steel enclosure, suitable for ac 23 duty and conforming to iec60947 maximum depth including handle 480mm suitable for switch board cabinet of lhb ac coach as per rdso letter no. el/7.1.108/mssbc dated 17.09.2021 & rdso letter no. el/6.8.21/tl-ac committee dated 11.05.2023 and rdso specification no. rdso/pe