Set of flange gaskets for mph & radiator pipe lines of ac electric locos, each set consists of 12 gaskets as follows.. 1) gasket as per ref no. 1 of s.c.rly drawing no. a3/el/conv/3/2698,alt-c qty/set-3 nos. 2) gasket as per ref no. 2 of s.c.rly drawing no. a3/el/conv/3/2698, alt-c qty/set-3 nos. 3) gasket as per ref no. 3 of s.c.rly drawing no. a3/el/conv/3/2698, alt-c qty/set-4 nos. 4) gasket as per ref no. 4 of s.c. rly drawing no a3/el/conv/3/2698, alt-c qty/set-2 no

Gear case assembly. complete for tm type hs 15250a as per scr drawing no. a1/el/conv/2669.

Laminated glass for wind screen for modified wap-4, wag-9 and wap-7 locos as per s.c.rly drawing.no. a4/el/conv/2671 alt-2 or latest

Single coil spring washer conforming to rdso drawing. no. t-10773

Set of drivers seat (1 set consisit 2 nos.) and backrest conforming to els/lgd drawing no. c/els/lgd/b.f/3/15 alt-1 or latest if any.

Bolster spring outer for blc wagon as per rdso drawing no. contr-9404-s/7, alt7, item no.1 conforming to rdso specification no. wd-01-hls-94 (rev.04) of june 2022.

Belt tensioning device for 25kw brushless alternator conforming rdso/elec/dte/skel/3940 (sheet-i alt. 5 & sheet-ii alt.5) with modified spring conforming to rdso drg. no. rdso/pe/sk/ac/0068-2004 (rev-0). however, the firms may quote for latest specn./drawing with amendment if any issued by rdso/icf/rcf/mcf etc.

Spares of automatic pressure modification (amp) device (el-60) for bmbs wagon consisting of 23 items as per attached annexure a . material and specification : as per drawing no. wd-08096-s-1 alt.2 & conforming to rdso s spec. no. wd-23 bmbs-2008 (rev.1), amend. no. 1 of sept-2016.

Spares of automatic pressure modification (amp) device (el-60) for bmbs wagon consisting of 23 items as per attached annexure a . material and specification : as per drawing no. wd-08096-s-1 alt.2 & conforming to rdso s spec. no. wd-23 bmbs-2008 (rev.1), amend. no. 1 of sept-2016.

Frp cleats suitable for 25 kw alternator, material conforming to rdso. drg. no.rdso/pe/sk/tl/4508-2009 [rev.1]. the size of cleat shall be 273 mm length x 35 mm width in two halves with 3 nos holes of 16 mm dia and 4 nos holes of 9 mm dia with 2 nos. of hex, nut bolts of size m8 x 70 with flat and spring washer for fixing the cleat as per drawing no. lgd/el/1454 enclosed