Open tenders like this

• Impact idler 324mm length as per enclosed drawing no. si no. 1 of hwpm/mu/238 (rev-0) sheet 3 of 3

  Directorate of Purchase and Stores | Department of Atomic Energy · Telangana Closes 05/11/2026

  View tender →

• Raw material fabrication/ machining finishing inspection packing & supply of bearing ring

  NUCLEAR POWER CORPORATION OF INDIA LIMITED | Department of Atomic Energy · Rajasthan Closes 06/11/2026

  View tender →

• Procurement of hydrogen seal rings for generator and mop front and rear bearings of 210 mw atps mppgcl chachai

  Madhya Pradesh Power Generating Company Limited | Chief Engineer(Gen.)-Amarkantak Thermal Power Station-Chachai - MPPGCL · Madhya Pradesh Closes 11/11/2026

  View tender →

• Tgb pads 6 segments,o rings of sizes as per terms and conditions,sliding ring 8 parts shaft seal segment as per oem drawing,standstill seal as per oem material number nbr60sh,pressure reducing valve samson make,fiber caps as per oem.

  Jammu and Kashmir State Power Development Corporation | Power Development Department Jammu and Kashmir · Jammu and Kashmir Closes 09/11/2026

  View tender →

• Clutch and pressure plate,rubber pipe head,clutch bearing with pipe,ring set standard,main bearing set standard,big end bearing set standard,head valve inlet and exhaust,crank thrust standard,engine gasket set eoh complete,valve cup seal,oil pump ass

  Jammu and Kashmir Police | Department of Jammu, Kashmir and Ladakh Affairs · Jammu and Kashmir Closes 13/11/2026

  View tender →

• Piston with pin and lock set std,piston ring set std,valve inlet and exhaust,engine oh gasket complete with head gasket valve oil seal,crank oil seal front and rear,cylinder linner set,main bearing 0.010 inch,big end bearing 0.010 inch,con rod bush s

  Indo Tibetan Border Police (ITBP) | Central Armed Police Forces · Chandigarh Closes 09/11/2026

  View tender →

• One time lock / pad lock seal (otl)specification: 1. material of hook-galvanized iron (gi) 2.wire diameter of hook 4 to 5mm 3. material of body(minimum) 30mm x 15mm (height) x 10mm (thickness)as per drawing enclosed. it can be locked by pressingthe metal portion towards plastic enclosure and whichcan be opened only by breaking its plastic body andcannot be reused. stenciling should be done as serial number one side and sr.dme/kur on other side with indelible ink. colour: orange / fluorescent g

  For complete description and other details, please refer to tender document.

  Ministry of Railways Closes 05/11/2026

  View tender →

• Head shaft as per enclosed drawing hwpm mu 683 r1,line shaft sleeve as per enclosed drawing hwpm mu

  Department of Atomic Energy | PMO Closed 05/08/2024

  View tender →

• Toothed hammer rings as per enclosed drawing no. hwpm mu 418 and annexure c,plain hammer rings as p

  Department of Atomic Energy | PMO Closed 11/08/2025

  View tender →

• Wear ring for air regulating ring as per drawing no. hwpm/mu/002

  Department of Atomic Energy | PMO Closed 16/08/2025

  View tender →