Fabrication of metallic end adaptor as per drawing no. cus 6210-251-r3,fabrication of metallic end adaptor as per drawing no. cus 6210-252-r1,fabrication of metallic end adaptor as per drawing no. cus 6210-253-r1,fabrication of metallic end adaptor as per drawing no. cus 6210-254-r1

Fabrication, inspection and supply of bottom end plugs as per drawing enclosed

Fabrication supply and installation of debris removal system as per drawing and specification

T-03 for dmg/tmc turning tool holder for dnmg 15 insert as per annexure-03 make-sandvik/walter/seco/

Fabrication and supply of tank tilting fixture as per attached drawing and specification(annexure-i)

Hdpe material granules,machine hacksaw blade,carbide side cutting tool,carbide side cutting tool,ms round bar,ms round bar,ms round bar,casting block,casting block,casting round,casting round,casting round,casting round,ms c channel,gi sheet,m.s. square bar,m.s. square bar,m.s. square bar,m.s. square bar,carbide boaring tool,rj 45 connector,hpmv lamp with holder,incandescent filament bulb,incandescent filament bulb,incandescent filament bulb,incandescent filament bulb,23 swg bare copper,1 by 18 pvc aluminium wire,3 by 20 pvc aluminium wire,7 by 20 pvc aluminium wire

Rough machined forging for u-ring as per drawing no. 41051424999 rev. 01,rough machined forging for u-sealing ring as per drawing no. 41050124992 rev. 03

Fabrication of bruchid trap,foldable net structure,vertical drilling machine,temperature regulated anaerobic reactor,drawing device-camera lucida,tractor front mounted loader small

Design, fabrication, decoration and maintaining of rbi stall at rajyotsav, atal nagar, naya raipur scheduled to be organized by csidc from november 01-03, 2026

1 - ecentric shaft with 2 nos. key for fly wheel and 2 nos. key for labyrinth seal, drawing no. - mark no. 1-154-011,1-154-a-011 make- tega mcnally mineral limited,2 - pitman housing cover, drawing no. - mark no. 2-332-012, 2-332-a-012 make- tega mcnally mineral limited,3 - intermediate labyrinth seal, drawing no. - mark no. 1-154-007, 1-154-a-007 make- tega mcnally mineral limited,4 - fixed side bearing inside cover, drawing no. - mark no. 1-154-007, 1-154-a-007 make- tega mcnally mineral limited,5 - fixed side bearing inside cover, drawing no. - mark no. 1-154-007, 1-154-b-007 make- tega mcnally mineral limited,6 - side bearing sleeve with pin, drawing no. - mark no. 2-332-016, 2-332-a-016 make- tega mcnally mineral limited,7 - sleeve push type removal, drawing no. - mark no. 3-145-010, 3-145-a-010 make- tega mcnally mineral limited,8 - lock washer w-36 make- tega mcnally mineral limited,9 - lock nut, an-36 make- tega mcnally mineral limited,10 - fixed side bearing cover, drawing no. - mark no. 2-332-014, 2