Turning tool holder as per iso key code no. scacr 2020 e 09 note-vender must give documentry evidence,plain turning tool holder similar to m/s sandvik cat. no. r171-31-2525-12 (iso identy code pclnr 2525,l. h. turning tool holder to iso identy code pclnl 2525 m-12.,bore turning tool holder(boring bar) to iso. identy code s16m-sclcr-09

Turning tool holder with rigid top clamp to iso code: dtjnl 4040 s-27, qty. 1 no. which is to be sup

Rule steel 30 cm graduated both english and metric units,plumb bob 115 grams,bradawl 150 mm x 6mm square pointed,rawl punch holder and bits no. 8,10,file second cut flat 20 cm with handle,spanners socket with speed handle,angle plate adjustable 250x150x175mm,punch centre 9mm x 150 mm,hammer cross peen with handle 250 grams,hacksaw frame fixed 150 mm,hand vice 50 mm jaw,table bench vice 100 mm jaw,chiesel cold flat 20 mm x 150 mm high carbon steel,hacksaw frame fixed type 300 mm,angle plate cast iron 150 x 150 x 250 mm,drill twist taper shank 8 mm to 20 mm by 0.5 mm h.s.s.,file triangular smooth 200 mm with handle,file round second cut 200 mm with handle,file triangular second cut. 200 mm with handle,file flat second cut safe edge. 300 mm with handle,file flat bastard 200 mm with handle,file half round bastard. 250 mm with handle,file round bastard. 250 mm with handle,file hand second cut. 150 mm with handle,file card or wire brush 3 inch x5 inch size, steel wire,scraper flat 150 mm with handle,scraper triangu

Carbide drill dia 6 mm type 2010-6.00 make: -ifanger/applitec/bimu or equivalent.,boring tool type 440100-r-k10 make: - ifanger/applitec/ bimu or equivalent.,boring tool type mten 425060-r-k10, tool will be used for finish boring, length of finish boring 3.9,boring tool type mten 425100 r-k10, tool will be used for finish boring, length of boring 8.00 mm, n,multi function tool holder dr-mf-16r 2.25 d: 01 no. insert xcmt 080304-mf-ic908: 50 nos. screw so 30,90 degree eco cut multifunction tool, over all length 94 mm, shank dia 20mm. ecc 16r-2.25 d08 - qty: