3 phase asynchronous traction motor (with shaft mounted zr. cu. stamping type resistance ring design of rotor, scheme-i for tm type 6fra 6068) for wag-9 locos with pinion type skdp 3847 without active speed sensor drg. no. 0twd.096.001 alt-3, spec. no.4tms.096.080 rev. 1, alt-5, str no. clw/2008/3phtm/str/0001 rev.1,alt-2.

Cu-cr-zr-ti block 60 x 50 x 50 mm,cu-cr-zr-ti sheet 3 x 200 x 200 - 1000 mm

Fly wheel ring,crank shaft pully,maint shaft key,llp sensor,o ring

Hp gasket ring (cu) (for compressor model no:wlna9bb).

Ring gauge for pinion shaft

Hydrogen seal ring for shaft assembly

Sealing ring,distance ring,key,impeller nut,rubber bearing,lock washer,o-ring,o-ring,o-ring,bearing spider,int shaft sleeve,rubber bearing,screwed coupling,o-ring,o-ring,head shaft,clamping plate,split gland,liqud deflector,shaft sleeve,distance sleeve,key,key,key,shaft sleeve nut,bearing nut,thrust collar,o-ring,o-ring,enclosed impeller,screwed coupling

Set of labyrinth ring, bearing cap and clamp plate (nde) for wap-7/wag-9 traction motor type 6fra 6068.

Terminal end tblr heavy duty cu 185mm2,terminal end cu 16mm2 type pin,terminal end tubular cu 10mm2,terminal end tubular cu 95mm2,terminal end tubular cu 150mm2 cus-242,terminal end tubular cu 35mm2,terminal end rect tongue fork cu 2 5mm2,terminal end rect tongue fork cu 4-6mm2,terminal end tubular cu 150mm2 cus-288,terminal end type pin 6mm2,terminal ring 16mm2 ref 7128,terminal flat 2 5mm2 ref cp 2,terminal end tubular cu 10mm2 cod cus-08

7.0 cu. m single bin hydraulic dumper placer mounted on 11, 990 kg gvw cng powered vehicle